Safe Talar Tunnel Placement During Reconstruction of the Deep Layer of the Deltoid Ligament: A Comparison of 4 Different Anatomic Landmarks on the Lateral Malleolus.

Abstract

Deltoid ligament reconstruction of the ankle can be considered when the ruptured ligament is insufficient for direct repair. To compare the safety of talar tunnels oriented toward 4 different anatomic landmarks on the lateral malleolus during reconstruction of the deep layer of the deltoid ligament (DDL). Descriptive laboratory study. A total of 30 computed tomography scans of the ankle joint in healthy adults were collected to generate 3-dimensional models. Virtual talar tunnels with a diameter of 5 mm and with different lengths (20.0, 25.0, and 30.0 mm) were created from the talar insertion of the DDL and were oriented toward the talar neck as well as the most anterior, the most distal, and the most posterior points of the distal fibula. The minimal safe distance (MSD) of a drilling route was calculated for the tunnels, and the safe distance from the end of the tunnel to the bone surface was measured for each tunnel. The nonpaired Student t test was used to detect differences among the safe distances of the 4 different bone tunnels. For the 20.0-mm tunnels, the safe distance of the tunnel oriented toward the talar neck (5.90 ± 1.16 mm) did not meet the MSD (6.0 mm). For the 25.0-mm tunnels, the safe distances of the tunnels oriented toward the talar neck (4.53 ± 1.13 mm) and the anterior point of the fibula (5.91 ± 1.52 mm) did not meet the MSD (6.9 mm). Tunnels that were 5 mm in diameter and 20.0 and 25.0 mm in length, oriented toward the most distal or most posterior point of the distal fibula, were safe for DDL reconstruction. Knowledge of safe talar tunnel placement is important, especially to avoid bone surface penetration during DDL reconstruction.