Abstract

Biological soil crusts (biocrusts) influence hydrological and erosive processes in drylands, and their effects increase with hypothetic successional development. Runoff and raindrops, both dependent on rain intensity, are among the main causes of erosion in these areas. However, little is known about the existence of soil loss nonlinearity in relation to rain intensity and crust types; this nonlinearity could control biocrust succession and dynamics. The assumption of biocrust types as successional stages, which allow space-for-time sampling, makes it advisable to include all the successional stages when exploring possible nonlinearity. We considered seven types of crusts, three physical and four biological. We created four rainfall intensity levels in controlled laboratory conditions: 18, 60, 120, and 240 mm/h. In all but the last, we conducted the experiments at two levels of antecedent soil moisture. Generalized Lineal Models enabled us to test for differences. These analyses confirmed previous knowledge regarding the significant effect of rainfall intensity, crust type and antecedent soil moisture and their interactions on runoff and soil loss, despite the small sample size of the sample units. For example, runoff, and particularly soil loss, decreased along succession. Moreover, some results were novel: the runoff coefficient increased only up to 120 mm/h of rain intensity. A decoupling between runoff and soil loss occurred at high intensities. Soil loss increased as rainfall intensity increased only up to 60 mm/h, and then it decreased, mainly due to physical crusts, because of the formation of a water sheet on the surface due to the incoming rainwater exceeding the drainage capacity. Although soil loss was greater in the incipient cyanobacteria than in the most developed lichen biocrust (Lepraria community), the protection provided by any biocrust against soil loss was great compared to the physical crust, and almost as strong at all rain intensities. Soil loss increased with antecedent soil moisture only in physical crusts. Biocrusts resisted the rain splash even at a rainfall intensity of 240 mm/h.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.