Abstract
Objective: A simple, sensitive, and accurate in-vitro dissolution method has been developed for Olmesartan Medoxomil (OLM), Chlorthalidone (CHLR) & Cilnidipine (CIL) drug combination according to USP dissolution testing methodologies with different discriminating mediums and validated as per ICH guidelines. Methods: The in-vitro dissolution profile was obtained using 900 ml of phosphate buffer pH 6.8 with 1.0% SLS at 37 °C ± 0.5 °C as dissolution medium and USP II (paddle) at 75 rpm. The average % in-vitro drug release was above 80% within 45 minutes for the above drug combination. The drug release profile was evaluated by RP-HPLC method. Chromatographic separation was done on Hypersil-BDS C-18 (12.5cm x 4.6mm x 5μm) column using gradient program with initial mobile phase ratio of 55:45 (v/v) mixture of ammonium acetate buffer (pH 5.0) and acetonitrile at a flow rate of 1.0 ml/min with detection wavelength 260 nm. Results: The method was validated with respect to specificity, linearity, precision, accuracy, and robustness. The method was found to be linear in the range of 7.0-21.0 μg/ml for CHLR (R2 = 0.9982), 22.5-67.5 μg/ml for OLM (R2 = 0.9999) and 5.5 -16.5 μg/ml for CIL (R2 = 0.9995) respectively. The % recovery data were found between 98.3 % to 104.1%. The % RSD for method and intermediate precision of method did not exceed more than 2%. Conclusion: The proposed in-vitro method can be applied successfully for routine quality control analysis to check the quality of above drug combination.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have