Abstract
Objective: The objective of this study is to investigate the experimental results of roundness error of machined holes using deep hole drilling process. The machining parameters include feed rate (f), spindle speed (s), depth of hole (d) and Minimum Quantity Lubrication MQL, (m). The work piece and tool material used in this study are Cold Mold Steel 718 and High Speed Steel, HSS (5mm diameter) with twist drill bit respectively. After that, to evaluate the quality of holes the roundness error has been used as machining performance. Method: A systematic approached based on Design of Experiment (DoE) was executed using Full Factorial design with added center point. Finding: Analysis of variance (ANOVA) was applied to the results to check the significance of the model. From the ANOVA analysis indicate that the model is significant for a confidence level of 0.05 or 95%.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.