Roughness effects on compressible turbulent boundary layers under different Mach numbers and wall temperature conditions

Abstract

Compressible turbulent boundary layers over a zero-pressure gradient flat plate with three-dimensional sinusoidal roughness are simulated by direct numerical simulation. The roughness effects on surface drag, velocity transformation, and turbulence fluctuation characteristics are analyzed in a wide range of Mach numbers (Ma∞ = 2.25–7.25) and different ratios of wall-to-recovery temperature (Tw/Taw = 0.43 and 0.84) conditions. It is found that the roughness significantly amplifies the surface drag coefficient due to the extra pressure drag induced by roughness, and the relative increase in surface drag induced by the roughness rises by 31.1% when Ma∞ changes from 2.25 to 7.25. Current compressible velocity transformations cannot make the logarithmic region of velocity profiles independent of Tw/Taw conditions for rough cases due to the strong wall heat transfer effect below roughness peak. Therefore, a new velocity transformation (Uρt+) is proposed to make the logarithmic region of Uρt+ profiles and roughness induced a downward shift of Uρt+ profiles (ΔUρt+) in a logarithmic region independent of Ma∞ and Tw/Taw conditions. Further numerical experiments validate that, in hypersonic boundary layers, the relation between ΔUρt+ and equivalent sand-grain roughness height Reynolds number still satisfies the roughness function proposed earlier for incompressible flows. Moreover, roughness significantly changes the distribution of mean turbulent kinetic energy (TKE) in compressible turbulent boundary layers: TKE is suppressed at the bottom of roughness, while reaching its maximum at the roughness peak, which is 50%–60% larger than that in smooth case. Finally, the expansion/compression wave patterns induced by roughness alter the turbulence fluctuations in outer layer.