Abstract
In this paper an improved back emf detection method is proposed. The motor neutral voltage is elemenated and the phase back emf zero crossing point can be directly extracted by detecting voltage difference between the phase terminal and the midpoint of the dc link. Here filtering circuit is not needed and the BLDC motor is provided with PWM control of 100% duty ratio which is presented in this paper. To perform the inverter commutation, there is a need of six commutation signals which is obtained by sensing only one of the three phase terminals that reduces the cost of the sensing circuit. The reduction of the imbalance in the six commutation signals which are caused by the asymmetrical behavior of the three phase windings in BLDC motor had been reduced in a varied speed range. It simplifies the starting procedure and achieve the motor performance over a wide speed range. This proposed method is analyzed through the simulation results using MATLAB Simulink. DOI: http://dx.doi.org/10.11591/telkomnika.v14i2.7423
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: TELKOMNIKA Indonesian Journal of Electrical Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
