Abstract

Abstract Root traits are important to crop functioning, yet there is little information about how root traits vary with shoot traits. Using a standardized protocol, we collected 160 soil cores (0−210 cm) across 10 locations, three years and multiple cropping systems (crops x management practices) in Iowa, USA. Maximum root biomass ranged from 1.2 to 2.8 Mg ha−1 in maize and 0.86 to 1.93 Mg ha−1 in soybean. The root:shoot (R:S) ratio ranged from 0.04 to 0.13 in maize and 0.09 to 0.26 in soybean. Maize produced 27 % more root biomass, 20 % longer roots, with 35 % higher carbon to nitrogen (C:N) ratio than soybean. In contrast, soybean had a 47 % greater R:S ratio than maize. The maize R:S ratio values were substantially lower than literature values, possibly due to differences in measurement methodologies, genotypes, and environment. In particular, we sampled at plant maturity rather than crop harvest to minimize the effect of senescence on measurements of shoots and roots. Maximum shoot biomass explained 70 % of the variation in root biomass, and the R:S ratio was positively correlated with the root C:N measured in both crops. Easily-measured environmental variables including temperature and precipitation were weakly associated with root traits. These results begin to fill an important knowledge gap that will enable better estimates of belowground net primary productivity and soil organic matter dynamics. Ultimately, the ability to explain variation in root mass production can be used to improve C and N budgets and modeling studies from crop to regional scales.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.