Room-Temperature Microfluidics Packaging Using Sequential Plasma Activation Process

Abstract

A sequential plasma activation process consisting of oxygen reactive ion etching (RIE) plasma and nitrogen radical plasma was applied for microfluidics packaging at room temperature. Si/glass and glass/glass wafers were activated by the oxygen RIE plasma followed by nitrogen microwave radicals. Then, the activated wafers were brought into contact in atmospheric pressure air with hand-applied pressure where they remained for 24 h. The wafers were bonded throughout the entire area and the bonding strength of the interface was as strong as the parents bulk wafers without any post-annealing process or wet chemical cleaning steps. Bonding strength considerably increased with the nitrogen radical treatment after oxygen RIE activation prior to bonding. Chemical reliability tests showed that the bonded interfaces of Si/Si could significantly withstand exposure to various microfluidics chemicals. Si/glass and glass/glass cavities formed by the sequential plasma activation process indicated hermetic sealing behavior. SiOx Ny was observed in the sequentially plasma-treated glass wafer, and it is attributed to binding of nitrogen with Si and oxygen and the implantation of N2 radical in the wafer. High bonding strength observed is attributed to a diffusion of absorbing water onto the wafer surfaces and a reaction between silicon oxynitride layers on the mating wafers. T-shape microfluidic channels were fabricated on glass wafers by bulk micromachining and the sequential plasma-activated bonding process at room temperature