Abstract
Austempered ductile irons (ADIs) with three strength grades were matched with high-carbon–chromium bearing steel and the rolling–sliding wear tests under high contact load were conducted on an Amsler type tribotester. During tests the contact surface was cooled by dry compressed air of 0.6MPa to prevent the surface oxidation by heating. The wear properties and behaviors of these friction pairs were investigated. The results show that the wear mechanism is delamination and the delamination of ADIs becomes mild with the increase of material hardness. The friction coefficient of the test pairs increases with the increase of material hardness and the surface microhardnesses of ADIs increase greatly during the tests due to the martensite transformation. The wear rates of three strength grades of ADIs show no obvious difference and the wear rates are influenced by both the material hardness and the friction coefficient.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
