Abstract
The trade-off between welding and strength loss of metal materials has been a troublesome question for decades. Improving joint efficiency is of considerable importance for industries. In the present study, grain refinement and rapid nanoscale precipitation in Al–Li alloys welds are concurrently achieved by ultrasonic enhanced friction stir welding (UFSW), improving the mechanical properties of joints. The results indicated that microstructures in the stir zone (SZ) were refined by the ultrasonic due to the enhanced dynamic recrystallization (DRX). Moreover, prominent nanoscale precipitation was observed in the SZ during UFSW. Under the effect of the ultrasonic, T1 (Al2CuLi) phases can precipitate through heterogeneous nucleation mechanism on a pre-existing θ′ (Al2Cu) phase, instead of starting from a supersaturated solid solution as that in traditional heat treatments. Therefore, both the precipitation velocity and nucleation rate were accelerated in UFSW. Based on the experimental discovery of orientation relationships between the T1 and θ′ phases (0001)T1//(312)θ′ and (2-1-10)T1//(-112)θ′, a theoretical model for T1 precipitation via heterogeneous nucleation was established, which coincided well with the observation by selected area electron diffraction. Excess vacancies introduced by the ultrasonic contributed to the enhanced DRX and nanoscale precipitation via the heterogeneous nucleation mechanism.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
