Role of the microtubule cytoskeleton in alternating changes in cellulose-microfibril orientation in the coenocytic green alga, Chaetomorpha moniligera

Abstract

The functions of the microtubule (MT) cytoskeleton in changing the orientation of microfibrils (MFs) in the cell walls of the coenocytic green alga Chaetomorpha moniligera Kjellman were investigated by electron microscopy. The cortical MT cytoskeleton in Chaetomorpha was comprised of longitudinally oriented MTs. Cellulose MFs, however, alternately changed their orientation longitudinally and transversely to form crisscross MF textures. Microtubules were parallel to longitudinally oriented MFs but never to those that were transversely oriented. The average density of MTs during the formation of longitudinally oriented MFs was 216 per 50 μm of wall and that of transversely oriented MFs 170/50 μm. To determine exactly the MT-density dependency of each MF orientation, changes in MF orientation were examined by changing MT density after treating and removing amiprophos-methyl (APM). Microtubules were reduced in number by a half (100/50 μm) after 2 h and by 3/4 (50/50 μm) after 3 h of treatment with APM (3 mM). This reduction was caused by the disappearance of alternating MTs. Microtubules retained this density (50/ 50 μm) up to 6 h, and then gradually disappeared within 24 h. Microfibril orientation in the innermost cell wall was transverse after treatment with APM for 2 h but was helicoidal after 6 h. Polymerization of MTs occurred in the longitudinal direction following the removal of APM after treatment for 48 h. Microtubule density rose to about 100/50 μm and 200/50 μm after 6 h and 24 h, respectively. The orientation of MTs changed from helicoidal to transverse and transverse to longitudinal after 6 h and 24 h, respectively. When APM was removed prior to formation of the helicoidal texture, longitudinally oriented MFs appeared within 6 h. There is thus an alternating cycle of formation of longitudinally and transversely oriented MFs within a 12-h period. Formation of transversely oriented MFs as a result of APM treatment started in the middle of a cell as hoops which then extended in the apical and basal directions. Formation of longitudinally oriented MFs as a result of the removal of APM started from the apical end and proceeded toward the base. It follows from these results that: (1) the point of formation of longitudinally oriented MFs differs from that for transversely oriented MFs, (2) MF orientation in each case depends on a separately functioning mechanism, (3) MT density changes rhythmically to trigger a switch for crisscross orientation of MFs.