Role of micro/nano fillers on mechanical and tribological properties of polyamide66/polypropylene composites

Abstract

The objectives of this research article is to evaluate the mechanical and tribological properties of polyamide66/polypropylene (PA66/PP) blend, graphite (Gr) filled PA66/PP, nanoclay (NC) filled PA66/PP and NC plus short carbon fiber (NC + SCF) filled PA66/PP composites. All composites were fabricated using a twin screw extruder followed by injection molding. The mechanical properties such as tensile, flexure, and impact strengths were investigated in accordance with ASTM standards. The friction and sliding wear behaviour was studied under dry sliding conditions against hard steel on a pin-on-disc apparatus. Scanning electron micrographs were used to analyze the fracture morphologies. From the experimental investigation, it was found that the presence of NC and SCF fillers improved the hardness of PA66/PP blend. Further, the study reveals that the tensile and flexural strength of NC + SCF filled PA66/PP was higher than that of PA66/PP blend. Inclusion of micro and nanofillers reduced the wear rate of PA66/PP blend. The wear loss of the composites increased with increasing sliding velocity. The lowest wear rate was observed for the blend with nanoclay and SCF fillers. The wear rates of the blends with micro/nanofillers vary from 30–81% and lower than that of PA66/PP blend. The wear resistance of the PA66/PP composites was found to be related to the stability of the transfer film on the counterface. The results have been supplemented with scanning electron micrographs to help understand the possible wear mechanisms.