Abstract
The effects of the silanization of multi-walled carbon nanotubes and graphene nanoplatelets with 3-APTES on thermal, mechanical and electrical properties of epoxy nanocomposites were investigated. Nanocomposites containing pristine, oxidized and silanized nanoparticles of multi-walled carbon nanotubes or graphene nanoplatelets at two different concentrations (0.15 and 0.50 vol.%) were prepared by in situ polymerization without using solvents. The functionalized nanoparticles were characterized by Fourier-transform infrared, X-ray photoelectron spectroscopy, Raman spectroscopy and transmission electron microscope techniques. The oxidation and the silanization on the surface of both nanoparticles were confirmed by Fourier-transform infrared, X-ray photoelectron spectroscopy, Raman and transmission electron microscope analysis. The thermal properties of all studied materials were analyzed by differential scanning calorimetry and the mechanical properties by nanoindentation. The addition of both nanoparticles (pristine and functionalized) into the matrix did not show significant variations on thermal properties, but decreased values for glass transition temperature (Tg) compared to the neat resin. Higher values for modulus of elasticity and hardness of epoxy/nanocomposites were obtained when silanized multi-walled carbon nanotubes or oxidized graphene nanoplatelets were added into the matrix. Adding 0.15 vol.% of silanized multi-walled carbon nanotubes the modulus of elasticity increased in approximately 60%, whereas 0.50 vol.% this increase was greater than 90% compared to the neat resin. While adding 0.15 vol.% of oxidized graphene nanoplatelets, the modulus of elasticity increased approximately 83%, whereas 0.50 vol.% this increase was greater than 88% compared to the neat resin. The formation of percolating networks has been achieved only by pristine multi-walled carbon nanotubes addition at a concentration of 0.50 vol.% and by silanized graphene nanoplatelets at a concentration of 0.15 vol.%. However, for both carbon-based nanoparticles conductivities on the order of 10−7 S/m for frequencies near 100 Hz were observed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.