Abstract

The microgrid (MG) concept is attracting considerable attention as a solution to energy deficiencies, especially in remote areas, but the intermittent nature of renewable sources and varying loads cause many control problems and thereby affect the quality of power within a microgrid operating in standalone mode. This might cause large frequency and voltage deviations in the system due to unpredictable output power fluctuations. Furthermore, without any main grid support, it is more complex to control and manage the system. In past, droop control and various other coordination control strategies have been presented to stabilize the microgrid frequency and voltages, but in order to utilize the available resources up to their maximum capacity in a positive way, new and robust control mechanisms are required. In this paper, a standalone microgrid is presented, which integrates renewable energy-based distributed generations and local loads. A fuzzy logic-based intelligent control technique is proposed to maintain the frequency and DC (direct current)-link voltage stability for sudden changes in load or generation power. Also from a frequency control perspective, a battery energy storage system (BESS) is suggested as a replacement for a synchronous generator to stabilize the nominal system frequency as a synchronous generator is unable to operate at its maximum efficiency while being controlled for stabilization purposes. Likewise, a super capacitor (SC) and BESS is used to stabilize DC bus voltages even though maximum possible energy is being extracted from renewable generated sources using maximum power point tracking. This newly proposed control method proves to be effective by reducing transient time, minimizing the frequency deviations, maintaining voltages even though maximum power point tracking is working and preventing generators from exceeding their power ratings during disturbances. However, due to the BESS limited capacity, load switching (load shedding scheme) as last option is also introduced in this paper. Simulation results prove the effectiveness of the proposed control strategy from both frequency and voltage perspectives.

Highlights

  • Remote microgrids (MGs) [1] have been widely developed, especially for rural and distant areas, where providing electric energy from the main utility grid is costly and has destructive environmental effects

  • Where NT represents the total number of modules, VMPPNS to be connected in series, NP in parallel, Vnominal is the rated voltage (220 V) and Ppvamax is the PV maximum size w.r.t power according to the where

  • NT represents the total number of modules, NS to be connected in series, NP in parallel, irradiation, whereas, corresponding area of PVA can be calculated as: Vnominal is the rated voltage (220 V) and Ppvamax is the PV maximum size w.r.t power according to the irradiation, whereas, corresponding area of PVA can be calculated as: SPVA = SPVModule ∗NT

Read more

Summary

Introduction

Remote microgrids (MGs) [1] have been widely developed, especially for rural and distant areas, where providing electric energy from the main utility grid is costly and has destructive environmental effects. This paper on a standalone hybrid microgrid based on wind generator, PV system, dump load and a fuzzy logic-based supervisory controller for power management, frequency and DG, supercapacitor, BESS, primary and secondary AC loads, DC heat generation system as dump stability. The microgrid generation of distributed resources, for supplying the demand side comprises the system design parameters aregenerator, listed in Table output power of the diesel wind turbine, photovoltaic system and battery energy storage. Power sources on the DC side of microgrid are a 60 kW PV system, 10 kW wind turbine and a solely in standalone mode to demonstrate frequency and voltage deviations that result from power battery energy storage system with a rating of 30 kW. The microgrid operates solely in standalone mode to demonstrate frequency and voltage deviations that result from power imbalance due to fluctuating renewable generation or varying loads.

Diesel
Photovoltaic
Wind Turbine
Supercapacitor as DC equations
Supercapacitor as DC Link
Bidirectional
Battery Charging Controller
Fuzzy Logic Based Frequency and Voltage
Frequency and Voltage Stabilization
Fuzzy Logic Based Control System
Simulation
Frequency and Voltage
Frequency and Voltage Stabilization with Battery Charging and Discharging
12. System
16. Supercapacitor
Conclusions
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call