Abstract
Presents a robot control system dedicated to grinding large Francis turbines. The control system is based on an active force feedback system using a three‐axes force sensor attached to the robot’s end effector. This system offers high flexibility and robustness against workpiece positioning and grinding tool wear. It provides control of the grinding process parameters ensuring high productivity in addition to good grinding performance and grinding tool economy. The system was experimentally tested out on a MultiCraft 560 grinding robot.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.