Rib Reduction Technique in Patients with Isolated Chondrocostal Chest Wall Prominence Undergoing Breast Augmentation.

Abstract

When planning for breast augmentation, it is important to consider not only implant choice, surgical technique and patient desires, but also the chest wall shape and deformities or irregularities, which remain often underestimated. They can be responsible for implant malposition and breast asymmetry after augmentation. Chondrocostal junction prominence is a minor but frequent chest wall deformity. The aim of this study is to report a new technique for sculpturing isolated chondrocostal prominence deformities in patients undergoing breast augmentation. A retrospective study was conducted to review surgical outcomes of a novel technique for costal prominence sculpturing and reshaping in patients undergoing breast augmentation. After reaching the subpectoral space, an inferiorly-based perichondral-periosteal flap is harvested just above the prominence. Once the deformity is corrected, the perichondral flap is repositioned over the sculpted rib. A total of six patients presenting with isolated chondrocostal prominence underwent bilateral breast implant placement and costal reduction using the described technique. Three patients were primary augmentations while the remaining patients were two secondary breast augmentation and one augmentation mastopexy. No complications were reported. No additional pain was referred at the side of rib remodelling in comparison with the contralateral breast. All the patients were satisfied with cosmetic results. The described technique for contouring of isolated chondrocostal deformities is fast, easy reproducible and offers advantages over the standard partial rib reduction technique. It can prevent implant malposition and projection asymmetry, eventually enhancing breast augmentation outcomes. This journal requires that authors assign a level of evidence to each article. For a full description of these Evidence-Based Medicine ratings, please refer to the Table of Contents or the online Instructions to Authors www.springer.com/00266 .