Abstract
AbstractThe behavior of PVC changes drastically with the temperature and the method of sample preparation. In the steady‐state shear mode, upon a decrease of the rate of deformation, the data may show either a steady increase of the shear viscosity or a leveling off to a Newtonian plateau. In the dynamic test mode, both the storage modulus, G′, and the loss modulus, G″, show an effect of the yield stress. Only at temperatures above 210°C are flow curves normal for polymer melts obtained. Rigid and nonrigid PVC formulations have been tested in Weissenberg Rheogoniometer, using steady‐state or dynamic test modes at temperatures from 140 to 220°C. It was observed that yield affects elasticity more (measured by the first normal stress difference or the storage modulus) than viscosity (expressed by the shear stress or the loss modulus). The corrected for yield plots of elastic vs. viscous parameter can be easily interpreted in terms of a composite flow.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
