Abstract
Abstract The rheological properties of binary rubber-carbon black compounds at compositions 5, 20, 30, 40 and 50 volume percent carbon black have been investigated as well as ternary compounds with rubber/carbon black/oil compositions of 70/20/10, 60/20/20 and 50/20/30, respectively. The compounds were investigated using (1) a constant stress creep instrument at very low rates of deformation, (2) a rotational rheometer at intermediate shear rates and (3) a capillary extrusion instrument at higher shear rates. In experiment (1), it was found that below a critical yield stress, the strain becomes saturated and finite. Above this stress the strain becomes unbounded and the compound maintained a steady shear flow. This observation was made for all compounds investigated. The values of the yield stresses obtained using the creep instrument were found to be significantly lower than those obtained from common extrapolations from rotational and capillary rheometers. In the ternary compounds it was also observed that as the oil content increases, not only the viscosity but the yield stress is reduced significantly. This observation is important because it can throw light on the type of interactions between carbon black and the rubber matrix.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.