Rheological properties, crystallization, and morphology of compatibilized blends of isotactic polypropylene and polyamide

Abstract

Blends of isotactic polypropylene (iPP) with the polyamide nylon-6 (N6), prepared by extrusion, were studied with a composition of up to 30% by weight polyamide. In the case of a 70/30 iPP/N6 blend, the influence of a compatibilizing agent based on polypropylene functionalized with maleic anhydride (PP-g-MA), with compositions of 1, 3, 5, and 10% by weight in polypropylene, was followed. The influence of the concentration of N6 and the compatibilizing agent on the rheological and thermal properties, and the morphology of the blends, was analyzed by monitoring the melt viscosity at different shear rates, differential scanning calorimetry, and polarized light microscopy. Vibrational spectroscopy was used to characterize the blends and to study the effect of the compatibilizing agent. The viscosity—composition curves for the iPP/N6 blends, in the composition and shear rate ranges analyzed, show a negative deviation from the additive rule, while the opposite trend is observed for the blends compatibilized with PP-g-MA. Important variations in the spectroscopic behavior was observed between compatibilized and noncompatibilized blends, which varied as a function of the compatibilizing agent concentration. The crystallization rates of iPP in the iPP/N6 blends, under both dynamic and isothermal conditions, are much greater than are those observed for pure iPP and are directly related to the nucleating activity of the polyamide. This effect is much smaller in the presence of the compatibilizing agent. The isothermal crystallization of the polyamide N6 in compatibilized blends is affected by the presence of iPP, reducing the crystallization rate due to the diluent effect of the polypropylene. © 1997 John Wiley & Sons, Inc. J Appl Polym Sci 65: 2665–2677, 1997