Abstract

AbstractFull Paper: The phase behavior of polystyrene (PS) and poly(vinyl methyl ether) (PVME) blend has been investigated rheologically as a function of temperature, composition and oscillating shear rate as well as different heating rates. An LCST (lower critical solution temperature)‐type phase diagram was detected rheologically from the sudden changes in the slopes of the dynamic temperature ramps of G′ at given heating and shear rate values. The rheological cloud points were dependent on the heating rate, $\dot q$, and oscillating shear rate, $\dot \gamma$. The cloud points shifted a few degrees to higher temperatures with increasing $\dot q$ and reached an equilibrium value (heating rate independent) at $\dot q \geq 2$ °C/min. The phase diagrams of the blends detected at $\dot \gamma$ = 0.1 and 1 rad/s were located in lower temperature ranges than the quiescent phase diagram, i.e., oscillating shear rate induced‐demixing at these two values for the shear rate. On the other hand, at $\dot \gamma$ = 10 rad/s, the phase diagram shifted to higher temperatures, higher than the corresponding values found under quiescent conditions, i.e., shear induced‐mixing took place. Based on these two observations, shear induced‐demixing and shear induced‐mixing can be detected rheologically within a single composition at low and high shear rate values, respectively, and this is in good agreement with the previous investigation using simple shear flow techniques. In addition, the William, Landel and Ferry (WLF)‐superposition principle was found to be applicable only in the single‐phase regime; however, the principle broke‐down at a temperature higher than or equal to the cloud point. Furthermore, different spinodal phase diagrams were estimated at different oscillating shear rates based on the theoretical approach of Ajji and Choplin.Spinodal phase diagrams at different oscillating shear rates.magnified imageSpinodal phase diagrams at different oscillating shear rates.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.