Rheological analysis and EOR potential of surfactant treated single-step silica nanofluid at high temperature and salinity

Abstract

Single-step nanofluids have shown better stability and size control properties than conventional two-step nanofluids under similar conditions. However, for wide-spread oilfield acceptance, there is a need to investigate the role of oilfield conditions viz., temperature, salt and pH on stability of single-step nanofluids. Thus, in this study, single-step silica nanofluids were synthesized in base fluid (1000 ppm polyacrylamide, PAM) and their stability was investigated using methods such as dynamic light scattering (DLS) and rheological analysis to establish their viability as suitable enhanced oil recovery (EOR) agents. PAM is a widely used oilfield practically applicable polymer. Primarily, the single-step silica nanofluids were found to destabilize at higher temperatures (≥90 °C) due to thermal stability issues of PAM at high temperatures. This was also understood by PAM rheology. The inclusion of salt reduced the stability of nanofluids due to the suppression of inter-particle repulsive forces. The variation in pH also influenced nanofluid stability and pH range of 8–10 was observed for the stable behavior of nanofluids. The addition of an anionic surfactant (SDS) improved nanofluid stability by reducing salt-induced NP agglomeration; increasing surfactant concentration initially improved nanofluid resistance to salt induced agglomeration and at high surfactant concentrations, the nanofluids exhibited greater NP agglomeration even in the absence of salt. The oil recovery results also showed that surfactant use in the synthesis of silica nanofluid for oil recovery applications may provide better results than sole silica nanofluid. Based on the observations, surfactant treated single-step silica nanofluid use was found favorable for oilfield practices where conventional nanofluids may show challenges.