Abstract
AbstractComposite materials consisting of magnetic shape memory alloy particles and a polymer matrix combine the advantages of both material classes: the high achievable magnetic field induced strain (MFIS) of 6% of Ni‐Mn‐Ga with a ductile matrix. Engineering the particle‐matrix interface as well as matching stiffness of polymer matrix is of importance for achieving high reversible MFIS to use this material as actuator or damper. We investigated those properties for Ni50.9Mn27.1Ga22.0 and Ni50.3Mn24.6Ga25.1 polymer composites. Particles were produced by gently crushing melt‐extracted and subsequently annealed fibres. At room temperature, the Ni50.9Mn27.1Ga22.0 particles exhibit a 5M martensitic structure, while the Ni50.3Mn24.6Ga25.1 particles are austenitic. These particles were embedded into the polymer, either a stiff epoxy resin or a soft polyurethane. In response to an external applied magnetic field, the particles tend to relocate within the polyurethane due to its very low Young's modulus and magnetostatic interaction between particles. Slightly stiffer polymer matrices are advantageous for achieving controllable MFIS. In Ni50.9Mn27.1Ga22.0 epoxy composites, a MFIS of 0.1% was observed and was resettable by rotating the magnetic field by 90°. Furthermore, single fibre pull‐out tests indicated significant improvements of the interfacial properties when using silane coupling agent treated fibres.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.