Reverse shear on inclined planes at the tip of a sharp crack

Abstract

P lane strain plastic yielding at a crack tip has been represented by edge dislocations with Burgers vectors parallel to symmetrical planes inclined at 70° and 45° to the plane of the crack. The plastic displacement and the stresses near the crack tip were calculated by a numerical method and the effect of a reduction in applied stress was determined. Removal of the whole or a part of the initial load produces reverse shear in regions of the slip band nearest the crack tip. The amount of reverse shear depends only on the reduction in the load and not on its initial value. The reverse shear is associated with the presence of negative dislocations and the stresses near the crack tip may become compressive even though the applied (remote) stress is still tensile. The degree and extent of compression depends on the reduction in applied stress and on its original value. It is argued that the residual compressive stresses produced under fluctuating loads may produce crack closure and crack arrest. The effect of residual plasticity in a slip band left behind a growing crack has been estimated. It is shown that after an overload the excess residual plasticity opposing crack opening rises to a maximum value when the crack tip has advanced some distance from the point where the overload was applied.