Abstract

Many types of robot arms have been developed in the market. Whenever a robot arm broke down, it is a challenge to do reverse engineer and repair the robot arm. This project has successfully reused the existing 5 degrees of freedom robot arm structure and electronic components while replacing the controller with a new Programmable Logic Controller (PLC) and LLD model. The project uses the existing DC servo motor, encoder, sensors, power supply, and interface board. Since the structure and most electronic components are already available, they are important to be analyzed and understood before they can be reused. Hence the reverse engineering activities are needed. In addition, a low-cost PLC is used to save cost. Thus, it is not possible to move all axes at the same time. Instead, the robot arm can only move one axis at a time. Additionally, the robot arm has been improved to be able to be programmed manually or automatically and repeat previously predetermined position sequences. In total, 90 rungs, 96 built-in commands, and custom functions have been used. The refurbished system is very stable and reliable.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.