Reverse coronal deformity: use of robotic total knee arthroplasty for identification and correction.

Abstract

Despite continued advances in techniques and implant designs, a population of patients who are dissatisfied after total knee arthroplasty (TKA) remains. During robotic-assisted arthroplasty, real-time intraoperative assessment of patient knee alignment is performed. Here, we assess the prevalence of an under-appreciated deformity, reverse coronal deformity (RCD), and the benefits of utilizing robotic-assisted knee arthroplasty to help correct this dynamic deformity. A retrospective study evaluating patients undergoing robotic-assisted cruciate-retaining TKA was performed. Intraoperative measurements were obtained using tibial and femoral arrays to assess coronal plane deformity at full extension and at 90° flexion. RCD was defined as ≥ 2° varus in knee extension that reversed to ≥ 2° valgus in flexion, or vice-versa. Coronal plane deformity was then reassessed after robotic-assisted bony resection and implant placement. Of 204 patients that underwent TKA, 16 patients (7.8%) were found to have RCD, with 14 patients (87.5%) transitioning from varus in extension to valgus in flexion. The average coronal deformity was 7.75°, with a maximum of 12°. These improved to an average coronal change of 0.93° post-TKA. Final medial and lateral gaps were all balanced to within 1° in extension and flexion. Another 34 patients (16.7%) had ≥ 5° change in coronal plane deformity from extension to flexion (average 6.39°), however, did not experience a reversal of their coronal deformity. Outcomes were assessed with KOOS Jr. scores postoperatively. Computer and robotic assistance were utilized to demonstrate the prevalence of RCD. We also demonstrated accurate identification and successfully balancing of RCD utilizing robotic-assisted TKA. An increased awareness of these dynamic deformities could aid surgeons in proper gap balancing even in the absence of navigation and robotic-assisted surgery.