Abstract
ObjectivesRedo surgery for pelvic fracture urethral distraction defects (PFUDDs) is still a challenge. the long urethral defect makes it difficult while the high tension increase the recurrence rate. Although certain ancillary maneuvers can relieve tension, there is no consensus or guidelines for the prediction/planning of the selection. In this study, we present our experience with developing an intraoperative guidance system to achieve tension-free urethral anastomosis.Patients and methodsA total of 91 recurrent PFUDD patients managed at our center between 2020 and 2022 were retrospectively analyzed. The patients underwent scar removing and urethral anastomosis. For the long defect and high-tension cases, 6 kinds of tension-relieving maneuvers were used respectively during the process of urethral anastomosis. Preoperative assessment of the urethrogram was done before surgery, while biaxial (vertical and horizontal) defect measurements were performed intraoperatively. The patients were followed-up for 12 months (8.9 ± 4.2), furthermore, recurrence and complications were analyzed.ResultsThe overall success rate was 86.81%. The mean defect in urethrogram was 2.9 ± 1.1 cm. 27 simple anastomosis was performed when the vertical plus horizontal defect was less than 2 cm with 11.11% recurrence. 24 cavernous septum splittings were performed when the horizontal defect was greater than 2 cm with 8.33% recurrence. 21 inferior pubectomies were performed when the horizontal defect was greater than 3 cm with 19.05% recurrence. 15 ancillary distal urethra manipulations (fully distal urethral mobilization, urethral suspension and corpus cavernosa folding) were performed when the vertical defect was 3 to 4 cm with 13.33 recurrence. 4 reroutings were performed when the vertical defect was greater than 4 cm with 25.00% recurrence.ConclusionsAncillary maneuvers are effective for reducing tension in redo urethral anastomosis. Measurement of divergent vertical and horizontal urethral defects could guide the selection of ancillary maneuvers. Combined tension-relieving maneuvers is recommended according to the defect direction and length to achieve a tension-free anastomosis.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.