Reticulated porous lanthanum strontium manganite structures for solar thermochemical hydrogen production

Abstract

Porous ceramic foams are utilized in various fields and applications due to their advantageous properties such as high porosity, high specific surface area, and controlled permeability. Non-stoichiometric oxide foams are of particular interest for the solar thermochemical production of hydrogen in directly irradiated solar receivers due to their enhanced heat transfer capabilities and structural integrity. We report the fabrication of lanthanum strontium manganite replica foams and their solar thermochemical water splitting performance. Highly porous (>80%) foams were produced with controlled structure and tested in a high temperature water splitting furnace to demonstrate stability and overall performance. The temperature profile of the burnout and sintering of the foam structure were altered based on simultaneous differential scanning calorimetry and thermal gravimetry analysis. Two-step sintering was used both to retain micron-sized pores (D50 = 0.4 μm) on the foam's struts and to limit grain growth to a grain size of ∼1 μm. The structural characteristics were confirmed by porosimetry and scanning electron microscopy. The foams were repeatedly cycled, producing approximately 200 μmol/g of H2 per cycle. Water splitting performance was tested for 50 cycles and approximately 35 h at 1400 °C. No statistical difference in the effective hydrogen production per cycle was observed, which is promising for long-term redox cycle stability.