Retention indexes for temperature-programmed gas chromatography of polychlorinated biphenyls.

Abstract

A noninteger retention index was defined based on a series of PCB internal standards, namely congeners 8 (2,4'-dichlorobiphenyl), 31 (2,4',5-trichlorobiphenyl), 44 (2,2',3,5'-tetrachlorobiphenyl), 101 (2,2',4,5,5'-pentachlorobiphenyl), 138 (2,2',3,4,4',5'-hexachlorobiphenyl), 180 (2,2',3,4,4',5,5'-heptachlorobiphenyl), and 194 (2,2',3,3',4,4',5,5'-octachlorobiphenyl). These retention index markers are common congeners present in technical mixtures and most environmental samples, and they show a linear dependence of retention time on the number of chlorine atoms, in the temperature-programmed analysis. The index values are calculated with a single regression equation instead of the Van den Dool and Kratz equation. The retention indexes of all 209 PCBs on two commonly used columns (DB-XLB and DB-5), as well as on a supplementary column of DB-17 in capillary gas chromatography, were determined using this system. The reliability of the retention index is quite good, with the average 95% confidence limits for three measurements on each PCB being +/-0.1 index unit under the same chromatographic conditions and +/-0.4 index unit under different column head pressures. The effect of heating rate of the programmed runs on the retention index was also investigated. The inversion of the elution order of some congener pairs on the DB-XLB column for different temperature heating rates was observed. Our index values were compared with those of Castello and Testini.