Abstract

The main objective of this work is to correlate the different attributes of retained austenite phase in TRIP steel structure with its mechanical properties. Three different chemical compositions were used to produce TRIP steel alloys. The first alloy contains only silicon as a carbide precipitation inhibitor; in the second alloy, silicon is partially replaced with aluminum, while in the third alloy phosphorus is added to the silicon–aluminum alloy. These compositions were proposed in order to avoid the negative effect of silicon during galvanizing. These three steel alloys were cast, homogenized, hot-forged and then subjected to intercritical annealing treatment followed by cooling and isothermal treatment in salt bath with subsequent air-cooling. Microstructural characterization, using optical microscope, SEM and XRD, along with tensile testing was carried out. Retained austenite attributes include volume fraction, carbon content, total carbon content, retained austenite transformable index and its stability coefficient against strain-induced martensite (SIM) transformation. The effect of these attributes on the mechanical properties of the studied TRIP steel alloys was evaluated using tensile test date, i.e., ultimate tensile strength (UTS), ductility, yield strength to UTS ratio, performance index and strain-hardening exponent. The variation of strain-hardening rate and strain-hardening exponent with strain was also considered. The failure behavior of the studied steel alloys was investigated using SEM on tensile-tested specimens. The results show that Si/Al-alloy has the lowest retained austenite transformable index, lowest stability coefficient against SIM transformation, highest performance index and more stable and uniform variation in strain-hardening rate and strain-hardening exponent with strain. These properties satisfy the industrial constrains of the sheets used in automotive industry relating to better mechanical properties and galvanizability.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call