Abstract
AbstractThe traditional method for shaping ceramics is by slip casting on gypsum molds; however, its application for near‐net shaping of ceramic components is limited due to contamination by calcium ions. The focus of this study is the modification of the mold to limit Ca2+ contamination and to maintain favorable sucking properties. Cement was added to a standard gypsum mold to suppress its erosion, and a decrease in the sucking rate was observed due to its reduced macroporosity. The highest values of green densities were obtained at gypsum/cement weight ratios of 90/10 and 70/30. The microstructure analysis showed that alumina blocks prepared from the molds containing higher quantities of cement (30 or 50 wt%) were resistant to abnormal grain growth caused by Ca2+ contamination from the gypsum. The gypsum/cement mixtures for making molds for slip casting significantly limit mold erosion due to a lower sucking rate and abnormal grain growth of the slip cast samples because of the decreased diffusivity of Ca2+ ions. Therefore, the present modification of the mold renders the slip casting method more suitable for the near‐net shaping of ceramics.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Applied Ceramic Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
