Abstract
The Janus Green B (JGB) adsorption onto homemade ZnO/Zn(OH)2 nanoparticles loaded on activated carbon (AC) which characterized by FESEM and XRD analysis has been reported. Combination of response surface methodology (RSM) and central composite design (CCD) has been employed to model and optimize variables using STATISTICA 10.0 software. The influence of parameters over pH (2.0–8.0), adsorbent (0.004–0.012g), sonication time (4–8min) and JGB concentration (3–21mgL−1) on JGB removal percentage was investigated and their main and interaction contribution was examined. It was revealed that 21mgL−1 JGB, 0.012g ZnO/Zn(OH)2-NP-AC at pH 7.0 and 7min sonication time permit to achieve removal percentage more than 99%. Finally, a good agreement between experimental and predicted values after 7min was achieved using pseudo-second-order rate equation. The Langmuir adsorption is appropriate for correlation of equilibrium data. The small amount of adsorbent (0.008–0.015g) is applicable for successful removal of JGB (RE>99%) in short time (7min) with high adsorption capacity (81.3–98.03mgg−1).
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Spectrochimica Acta Part A: Molecular and Biomolecular Spectroscopy
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.