Abstract
Health monitoring of bearings is one of the important tasks in many industries. A number of techniques are used for bearing fault detection in which vibration based signal analysis is the most commonly used technique. The current work emphasizes the comparison of some of the parameters of vibration acceleration signal such as Peak to Peak amplitude, Peak Amplitude and RMS amplitude which are used in the detection of defects in bearings. These parameters are measured at various loads and speeds with simulated defect on bearing parts. The graphs plotted depicts that Peak to Peak amplitude gives better defect detectability whether it is on outer ring, inner ring or on the ball.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
