Abstract
Granite residual soil is a special regional soil with special mineral composition and pore structure characteristics, which is easy to induce serious geological disasters or engineering problems, so it is particularly important to study its mechanical properties of unsaturated soil and its control mechanism. However, the effects of dry density and initial water content on soil–water characteristic curve (SWCC) and their mechanisms are still unclear. Therefore, samples with different dry densities (1.30 g/cm3, 1.50 g/cm3, 1.70 g/cm3) and initial water content (14 %, 20 %, 22 %) were set up in this paper. SWCC test was conducted on the two groups of samples under the humidification path and dehumidification path using filter paper method. Combined with scanning electron microscopy (SEM) test and pore-size distribution (PSD) test, the influence mechanism of different micro-pore structure on SWCC and hysteresis characteristics of granite residual soil was analyzed qualitatively and quantitatively. The results show that the samples with different dry densities basically coincide with each other in the high suction segment. The larger the dry density is, the smaller the range of transition zone in the low suction segment is. As the initial water content of the sample increases from 14 % to 22 %, SWCC changes from a single increase curve to a double increase curve, and the corresponding pore-size distribution curve (PSDC) changes from a trimodal curve to a bimodal curve. The SWCC of granite residual soil has obvious hysteresis effect, and the hysteresis area becomes smaller with the increase of dry density. The inflection point exists in the hysteresis area of SWCCS with higher initial water content. The distribution range of macropore is determined by dry density, and the distribution range of small pore is determined by initial water content. The transformation of SWCC from a single increase curve to a double increase curve is mainly controlled by the distribution range of small pores. The bottleneck effect in the migration process of pore water in the soil and the pore redistribution during water intake and water loss are the main reason for the hysteresis of SWCC. The results of this work provide some guidance for the study of unsaturated soil mechanical properties of granite residual soils.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.