Abstract
Potentiometric sensors are studied as viable candidates for the construction of high throughput DNA arrays. For preliminary investigations, such sensors were used in an HPLC setup in the present work. This avoided errors due to ionic contaminants or additives in the commercial samples. The oligonucleotides dT(10), dT(20) and dT(30) were used as test substances. The potentiometric sensors were of the coated wire type, containing PVC, DOP, MTDDACl and a synthetic podand urea receptor. The HPLC system consisted of a reversed phase column eluted with a phosphate buffer, triethylammoniumacetate (TEAA), and an acetonitrile gradient. Molar responses and sensitivities increased with increasing chain length of oligonucleotides, yielding detection limits as low as 10(-6)M (dT(30), injected concentration). The slopes of the calibration graphs were at least 23 mV/decade (dT(10)), which was much higher than expected. The results are discussed in view of the potential use of this sensor type in high throughput microarrays.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Combinatorial Chemistry & High Throughput Screening
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
