Respirable Dust Control in Grinding Gray Iron Castings

Abstract

High speed grinding of gray iron castings long has been associated with excessive exposure to crystalline silica. Not all workers engaged in these operations are protected by conventional ventilation techniques. Dust in the air that has been entrained by the spinning grinding wheel and not captured in the grinder hood has been postulated to be a major exposure source. A pilot grinding operation was constructed, and the size distribution and concentration of airborne particles were measured with the aerodynamic particle sizer (APS). Various control measures proved effective in reducing the respirable dust concentration: increased exhaust ventilation, and installation of baffles and/or the use of an air jet to deflect the entrained air stream. The concentration of respirable dust is the breathing zone was reduced approximately 20-fold through the combined use of increased ventilation, interior baffles, and an air jet. The air jet and baffle utilized at the base ventilation rate reduced the respirable dust concentration by a factor of three to four, whereas the baffle alone halved the concentration.