Abstract
This paper presents in detail the entire procedure of calculating the bias resistance of an ohmic RF-MEMS switch, controlled under resistive damping (charge drive technique). In case of a very stiff device, like the North Eastern University switch, the actuation control under resistive damping is the only way to achieve controllability. Due to the short switching time as well as the high actuation voltage, it is not practical to apply a tailored control pulse (voltage drive control technique). Implementing a bias resistor of 33 MΩ in series with the voltage source, the impact velocity of the cantilever has been reduced 80 % (13.2 from 65.9 cm/s), eliminating bouncing and high initial impact force during the pull-down phase. However, this results in an affordable cost of switching time increase from 2.38 to 4.34 μs. During the release phase the amplitude of bouncing has also been reduced 34 % (174 from 255 nm), providing significant improvement in both switching operation phases of the switch.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
