Abstract
In this study, the resistance change characteristics of the carbon nanotube (CNT) thin films supported by rubber or resin sheets were examined for application in displacement and motion sensors. The CNT film was prepared by the spray deposition method, which is a simple and low-cost process. The resistance change of the CNT sheets caused by bending the CNT sheet was examined. The CNT sheets exhibited resistance changes which was dependent on the bending deformation applied. Results from this study show that the sensitivity of the CNT sheets strongly depends on the deposition condition of the CNT films.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
