Resin Infusion under Flexible Tooling (RIFT): a review

Abstract

Increasing legislation to limit styrene emissions (mainly from polyester resin systems) into the work place has been the key factor in promoting new technology in the manufacture of fibre reinforced plastics composites. Styrene emissions can be reduced by the development of: resin systems with low styrene emission; improved ventilation and air filtering systems; closed moulding techniques. It is the final area on which this paper concentrates. RIFT is a variant of vacuum-driven RTM in which one of the solid tool faces is replaced by a flexible polymeric film. The process is known by several acronyms—in this paper it is referred to as RIFT (Resin Infusion under Flexible Tooling). Potentially a very clean and economical composites manufacturing method, the process draws resin into a dry reinforcement on an evacuated vacuum bagged tool using only the partial vacuum to drive the resin. It reduces worker contact with liquid resin whilst increasing component mechanical properties and fibre content by reducing voidage compared to hand lay-up. For higher performance composites, RIFT offers the potential for reduced tooling costs where matched tooling (RTM or compression moulding) is currently used. This paper reviews the progress of RIFT from its first development as the Marco method in 1950 to the Seemann Composites Resin Infusion Manufacture Process (SCRIMP) today. Development of the process has been slow (compared to RTM) and generally lacking in scientific rigour. Current research is reviewed and the potential for scientific development is discussed.