Residual thermal birefringence in freely quenched plates of amorphous polymers: Simulation and experiment

Abstract

AbstractFree quenching experiments were performed on thin plates of polystyrene (PS) and polycarbonate (PC). The thermal birefringence distribution along the thickness direction of the plates was measured. The birefringence data were compared with the results of a numerical simulation based on the linear viscoelastic and photoviscoelastic constitutive equations for the mechanical and optical properties, respectively, and the first‐order rate equation for volume relaxation. The effects of the initial temperature, quenching temperature, and quenching media on the development of residual thermal stresses and birefringence were evaluated. At higher initial temperatures (>105 °C), the thermal birefringence in quenched PS plates was negative at the center and positive at the surface, whereas at lower temperatures (close to the glass‐transition temperature), the birefringence became positive at the core and negative at the surface or positive through the entire cross section of the plate. The birefringence in freely quenching PC plates was positive at the center and negative at the surface at any initial temperature. These observations were in fair agreement with predicted data. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 1850–1867, 2003