Abstract

Similar and dissimilar friction stir welds of AA5083 and AA6061 were produced modifying the location of the materials in the joint (advancing or retreating side) and travel speed (73 and 206 mm/min). Longitudinal and transverse residual stresses were evaluated by X-ray diffraction technique on the mid-length of each welded sample, in the transverse direction to the weld on a 42 mm distance. Unstrained lattice spacing (d0) and full width at half maximum (FWHM) were also measured. A peak of tension stress at the edge of stirred zone was detected, describing an “M” like profile, which were more asymmetrical for dissimilar joints. Variations in d0 and FWHM were also observed through the welded joint, which were related to microestructural changes.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.