Residual Stress Measurement of Plasma-Sprayed Coatings.

Abstract

Residual stresses of plasma sprayed coatings, NiCr alloy, CoNiCrAlY alloy, Al2O3 ceramics and ZrO2-8%Y2O3 ceramics, were measured in this study. SACHS method with a strain gauge was used to measure the residual stress. Type 304 stainless steel and mild steel were selected for the substrate. The results obtained were summarized as follows: 1) Tensile residual stresses were generated in plasma sprayed coatings. 2) The values of residual stress in ceramics coatings were relatively small and the values took lower than 40 MPa. 3) Tensile residual stress values of metal alloy coatings on carbon steel substrates were higher than those on type 304 stainless steel substrates. 4) Residual stresses in Low Pressure Plasma Sprayed (LPPS)-coatings were larger than those in Atmospheric Plasma Sprayed (APS)-coatings. 5) Pre-heating of a substrate will effectively reduce tensile residual stress in a coating.