Reservoir characteristics of Datta Formation (Early Jurassic), Marwat-Khisor Ranges, sub-Himalayas, Pakistan

Abstract

The present work has been accomplished to carry out a detailed study of the characteristics of the Early Jurassic Datta Formation of Trans-Indus Ranges, Pakistan. The discovery of Saib well-1 (Gas and condensate discovery from Jurassic limestone) in the study basin takes an active interest in carrying out extensive exploration activities in the same basin. Jurassic rocks especially Datta Sandstone and Samana Suk Limestone are acting as good reservoirs. The study unit consists of variegated sandstone interbedded with siltstone, carbonaceous clay, and shale and coal stringer. For the current work, two stratigraphic sections (Pezu and Abbo Wanda) have been measured. To examine its sedimentology, depositional environment, diagenetic settings, and reservoir characteristics, a detailed study was conducted and various laboratory techniques have been utilized. About 95 rock samples from the bottom to the top of both sections were collected, and 50 rock samples have been selected for thin section analysis and were examined under a polarizing microscope to show their mineralogical composition, diagenesis, and their reservoir characteristics. XRD (X-ray diffraction), Cathodoluminescence (CL), SEM (Scanning electron microscope) with EDS (Energy-dispersive spectroscope), and Core plug porosity and permeability analysis have been used to interpret its chemical and mineralogical composition and its reservoir characteristics, respectively. Based on field observations and thin section analysis, four depositional facies and six lithofacies have been established. The sedimentary structures, depositional facies, and lithofacies indicate that Datta Formation was deposited in a deltaic environment. Compactions, cementation, fracturing and dissolution can greatly affect the quality of reservoir rock. Based on thin section and SEM analysis, large numbers of primary pores, fracture and secondary pores were observed and connectivity between the pores is good, and at some places, these pores were filled through the authigenic clay minerals like kaolinite, mixed layers illite/smectite and chlorite that influences the reservoir characteristics. Primary pores (thin section) and secondary pores (dissolution pores) and core plug porosity and permeability data (porosity 13.23%–26.89% and permeability 0.12 to 149 mD) shows that Datta Formation has a good reservoir quality.