Abstract
The vibration tapping technology has been employed with success on some difficult-to-machine material such as titanium alloy, hardened steel and so on. However, there are very few studies on the application of the torsion vibration tapping in particle reinforced aluminum. The tapping performance of small size thread holes in particle reinforced aluminum matrix composites Al2O3p/Al and SiCp/Al during common tapping and low-frequency vibration tapping using high speed steal(HSS) machine-used taps is researched experimentally in this work. The influence of vibration parameters, e.g. cutting speed V, net forward angle of each stroke LT and times of repeat cutting Q on tapping torque, tool wear, tool life and quality of thread holes is investigated during the experimentation. The results show that the common vibration tapping with small amplitude, relatively high frequency and a lot of repeat cutting times suit to tap the Al2O3p/Al, whereas the step vibration tapping with large amplitude, relatively low frequency and a few repeat cutting times suit to tap the SiCp/Al due to difference performance of the two kinds of material. The influence of Q and LT on the quality of thread holes, tapping torque and tool life is sensitive on the Al2O3p/Al, whereas the influence of V and Q on the quality of thread holes, tool wear and tool life is sensitive on the SiCp/Al. Furthermore, the optimum vibration parameter in the Al2O3p/Al by dry cutting is cutting speed of 400r/min, net forward angle of each stroke of 1.5°, backward angle of each stroke of 45°. The optimum vibration parameter in SiCp/Al by dry cutting is cutting speed of 220r/min, net forward angle of each stroke of 420°, backward angle of each stroke of 430°. From the test results and micrographs, it was observed that the particle could be fractured on the surface finish on tapping processing. The proper vibration tapping parameter can void the adhesion in the tap flute, decrease the tapping torque, improve the quality of thread hole and prolong the tap life.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
