Abstract
Phasor measurement unit (PMU), which could provide high-frequency phasors including the amplitude and phase angle synchronized with Global Positioning System (GPS)/ BeiDou Navigation Satellite System (BDS) signal, plays vital role in dynamic monitoring of power system. However, if the GPS/BDS signal could not be received, the time of PMU, which is depending on the crystal oscillator, would have a measurement deviation provided by the frequency deviation (FDCO) of crystal oscillator. Meanwhile, due to high proportion of new energy power generation and power electronic equipment in power system, power system oscillation occurs frequently, and the measurement problems under oscillations have also become a hot topic of concern. Therefore, this paper analyzes and deduces the impact of constant crystal frequency deviation on PMU measurement when the system is oscillated. First, in the oscillation state, the phasor measured by the PMU in the case of the FDCO exists is derived. Then, the detailed analysis of the impact of different value of the FDCO on the PMU measurement is carried out. Finally, the impact of FDCO on angle and amplitude data of PMU measurements are verified with simulation, when the FDCO is small and large, respectively.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.