Abstract
An ECU hardware-in-loop simulation system for electronic-controlled engine in better real-time and augmentability is built. We establish a dynamic average model of the electronic-controlled engine and put emphasis on analysing its fuel and oil slick modelmass flow model of intake manifold air and the sub-model of inlet manifold pressure. The engine model has fewer parameters and lower orders in order to adjust and set parameters; We propose a building program based on virtual instrument technology and adopts the chip TMS320F2812-DSP to design a signal interface system used to achieve the simulation for sensor signal and the collection of ECU output signal. Through the verification of simulating experimental data, it's proved that the established model of electronic-controlled engine has suitable steps and good real-time performance, building a good foundation for further experimental design and research in the future.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.