Research on the Connection Technology of Assembled Monolithic Residential Wallboard

Abstract

In this paper, a novel technique for connecting residential shear walls to floor slabs is investigated. Shear wall structures with two different connection methods were established and numerically analyzed using ABAQUS (2024) finite element software. The two structures were connected by sleeve grouted connections (hereinafter referred to as the original structure) and profile + bolted connections (hereinafter referred to as the new structure). Numerical analyses yielded a positive maximum load for the new structure 1.41 times that of the original structure and a negative maximum load 1.12 times that of the original structure. The ratio of the ultimate tensile strength (load value corresponding to the peak point) to the yield strength (load value corresponding to the yield point) of the two structures (strength-to-yield ratio) was in the range of 1.15–1.27. The original structure was 2.62 times more ductile in the negative direction and 2.24 times more ductile in the positive direction than the new structure. The stiffness degradation of the new structure was greater in the later stages of loading, and that of the original structure was greater in the early stages of loading. The original structure had 1.08 times the energy-consuming capacity of the new structure. The cost of labor and materials for the original structure was approximately 1.50 times the cost of the new structure. The results of the data analysis showed that, compared to the original structure, the new structure had comparable performance in terms of strength-to-flexure ratio, ductility, stiffness degradation, and energy dissipation capacity. However, the new structure was more advantageous in terms of load-bearing capacity and required lower construction costs than the original structure. Therefore, the connection nodes designed in this paper are of great significance for engineering practice.