Research on the Adsorption Performance of Zeolites for Dimethyl Ether

Abstract

The purification and removal of polar impurities in olefin feedstocks is crucial for downstream deep processing, and adsorption is the main method for deep purification of such impurities. This article takes dimethyl ether, a typical oxygen-containing compound impurity in MTOs, as a polar impurity molecule, and LTA and FAU topological zeolites as research objects. The influence of zeolite topology, morphology, skeleton silicon–aluminum (Si/Al) ratio, and ion type on the adsorption and removal of trace dimethyl ether was investigated by XRD, SEM, XRF, and nitrogen adsorption–desorption methods. The FAU topological zeolites show a better adsorption performance for dimethyl ether owing to their larger specific surface area and unobstructed pores compared with LTA zeolites. Among FAU topological zeolites, the NaX zeolite a with lower framework silica–alumina ratio has the highest adsorption capacity for dimethyl ether. Magnesium ion exchange on NaX zeolites (MgNaX) reduce the specific surface area and adsorption capacity of the NaX zeolite. However, after forming with alumina as a binder, the adsorption capacity of the MgNaX–Al2O3 adsorbent is about 13% higher than that of the NaX–Al2O3 adsorbent without Mg ion exchange. This may be due to the decomposition of residual organic Mg salts in the Mg ion exchange samples during high-temperature calcination, resulting in a larger specific surface area for the formed adsorbent. Further characterization of NH3–TPD and CO2–TPD shows that Mg ion exchange weakens the acid–base active sites on the adsorbent surface. The reduction in acid–base sites reduces the occurrence of side reactions such as polymerization and isomerization caused by the exothermic adsorption of olefins on adsorbents. Repeated adsorption data show that the formed adsorbent has excellent regeneration–adsorption performance.