Abstract
The study presents a new method for 5-axis machining of blisk, which consists of both roughing tunnels and finishing blades. The ruled surface is used to approximate the freeform surface of blade, and the boundary contour of the tunnel is then determined. Based on the double point offset method, the 5-axis tool paths for roughing blisk tunnel region are generated. Similarly, by linking the corresponding points on the tool center curves and the tool axis drive curves, the spiral tool paths are developed to finish milling thin-walled blades taking into account the residual stresses induced part distortion during machining. This strategy is experimentally verified.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
