Research on Performance Evaluation of Polymeric Surfactant Cleaning Gel-Breaking Fluid (GBF) and Its Enhanced Oil Recovery (EOR) Effect.

Abstract

Clean fracturing fluid has the characteristics of being environmentally friendly and causing little damage to reservoirs. Meanwhile, its backflow gel-breaking fluids (GBFs) can be reutilized as an oil displacement agent. This paper systematically evaluates the feasibility and EOR mechanism of a GBF based on a polymer surfactant as an oil displacement system for reutilization. A rotating interfacial tensiometer and contact angle measuring instrument were used to evaluate the performance of reducing the oil-water interfacial tension (IFT) and to change the rock wettability, respectively. Additionally, a homogeneous apparatus was used to prepare emulsions to evaluate GBF's emulsifying properties. Finally, core flooding experiments were used to evaluate the EOR effect of GBFs, and the influence rules and main controlling effects of various properties on the EOR were clarified. As the concentration of GBFs increases, the IFT first decreases to the lowest of 0.37 mN/m at 0.20 wt% and then increases and the contact angle of the rock wall decreases from 129° and stabilizes at 42°. Meanwhile, the emulsion droplet size gradually decreases and stabilizes with increases in GBF concentration, and the smallest particle size occurs when the concentration is 0.12-0.15 wt%. The limited adsorption area of the oil-water interface and the long molecular chain are the main reasons that limit the continued IFT reduction and emulsion stability. The oil displacement experiment shows that the concentration of GBF solution to obtain the best EOR effect is 0.15 wt%. At this concentration, the IFT reduction and the emulsification performance are not optimal. This shows that the IFT reduction performance, reservoir wettability change performance, and emulsification performance jointly determine the EOR effect of GBFs. In contrast, the emulsifying performance of GBFs is the main controlling factor for the EOR. Finally, the optimal application concentration of GBFs is 0.15-0.20 wt%, and the optimal injection volume is 0.5 PV.