Research on Microstructure and Cracking Behavior of Al-6.2Zn-2Mg-xSc-xZr Alloy Fabricated by Selective Laser Melting

Abstract

Selective laser melting (SLM) offers obvious advantages in the production of complex parts. However, the traditional 7xxx series aluminum alloy has a serious cracking tendency in the SLM process. Therefore, in order to analyze the microstructure and cracking mechanism, and obtain crack-free aluminum alloy fabricated by SLM, this paper studied the microstructure characteristics of as-deposited Al-6.2Zn-2Mg-xSc-xZr alloy with different Sc, Zr content, as well as the influence mechanism of Sc, Zr on cracking. The results show that with the increase of Sc and Zr content, the crack tendency and grain size decrease. When Sc and Zr content reach 0.6% and 0.36% respectively, cracks can no longer be observed in the as deposited alloy. The microstructure of the as deposited Al-6.2Zn-2Mg-0.6Sc-0.36Zr alloy consists of fine equiaxed and columnar crystals, in which Sc and Zr mainly exist in the aluminum matrix as solid solutions, and some exist in the form of Al3(Sc, Zr). The immediate reason for the absence of cracks is that the microstructure changes from coarse columnar grains to fine equiaxed-columnar grains when the content of Sc and Zr increases. The refined grain size may have the following beneficial effects: It helps with reducing the thickness of the liquid films. This will increase the tear sensitivity of the liquid film and the cracking tendency and therefore lowers the hot cracking tendency; And a refined grain size improves fracture roughness, leading to an enhanced cracking resistance. At the same time, the refinement of the grains will make the feeding channel of the grain boundary shorter and easy to feed, and the fine equiaxed grains can coordinate stress-strain during solidification more effectively than coarse columnar grains, which will decrease the cracking tendency.